Jag kan ge dig en knuff i rätt riktning. Så det blir lättare för dig hitta problemet.Visserligen på engelska. Men det är inte svårt.Directions:Turn your key to have the lights on.Set the multifunction gauge to engine hours.Press and hold the selector button while QUICKLY toggling the HI-LO beam 3 times.Continue holding the selector button. ACTIVE P_CODE should show up on the gauge.If there are any fault codes to be read they will begin with a P followed by 4 numbers. Otherwise END will appear.To exit this diagnostic mode, press and hold the selector button again for 2 seconds.Om du får upp någon felkod så skulle jag gissa att den finns med på första bilden i den här serien. http://www.flickr.com/photos/22105723@N04/sets/72157618532917232/bara att välja "Large" på bilderna å spara ner. Hoppas detta hjälper dig.